How To Use Bondo
How To Use Bondo. If the pro bondo piece doesn't feel as tacky as it should, try washing the back in ipa which will reactivate the adhesive agent. Fill the freezer bag with the bondo mixture, then snip off a corner of the bag and use it to squeeze the bondo into tight areas.
Replace large sections of missing wood with new wood. It should be used as it is. Pay attention to the mixing ratio.
You Are Advised To Scuff Or Sand It First.
Take a bondo spreader and thoroughly mix the two components together by swiping the mixture back and forth across your pallet, folding the. Only wipe the filler on the surface in one direction, or. Mix and apply bondo all purpose putty.
How To Use Bondo Body Filler Step 1.
Bondo isn’t designed to be thinned. Sand smooth after it hardens. Locate the filler and the hardener from the bondo kit.
If The Repair Is Very Deep You May Want To Do Two Coats.
Clean away all soft wood rot or use hardener to harden the soft wood. Use the plastic spreader included with the bondo kit to spread the mixed filler over the area to be repaired by using a firm wiping motion. Clean the bondo off the spreader and mixing board as soon as it gets rubbery and roll it into a ball.
Run The Ball Over The Surform Blade, And As Soon As It Carves, Shave Off The High Spots Off The Repair Area With The.
The bondo body filler is applied using a putty knife or a bondo spreader. Replace large sections of missing wood with new wood. Using your putty knife and spreader, apply bondo to the surface that has been created by your fiberglass and epoxy.
Most Of This Comes From Experience, But.
How do you apply bondo over fiberglass? Before explaining how to thin bondo, let’s answer the above question. When bondo is applied on top of it, it has trouble holding on.
0 Response to "How To Use Bondo"
Posting Komentar