How To Use An Iron On Patch

How To Use An Iron On Patch. To save time, plug your iron in while you are deciding on where to position your patches. After the time is up try to lift some of the edges while holding down the rest of it.

How to Iron On Patches. Follow These Steps and Enjoy Your from www.pinterest.com

Using an iron with steam, iron the fabric/fusible web onto the knee patch for a full 30 seconds on high heat. Place the iron over the patch and cloth and hold it there for 30 seconds. Set your hand iron at the hottest temperature setting.

Start Pressing In The Middle And Work Out To The Edges To Avoid Any Bubbles.

Let the iron get hot, then place the pants on the ironing board. Place your applique or embroidered patch in the desired position and place a pressing cloth (such as a handkerchief, sheet or pillowcase fabric) over top. Take a scrap of denim and place it inside the pant leg, beneath the hole.

Peel The Paper Backing Off Of The Patch When Ready To Apply To Your Project.

Heat fuse the adhesive to the patch. Iron on appliques and embroidered patch setting instructions using an iron: If you forgot, plug the iron in and allow the iron to reach the correct temperature.

Please Follow The Instructions That Come With The Ironing Patch:

It should penetrate the glue layer easier than other needles. Which is more than enough for most jackets and bags, but for. If you can, wash the garment (s) by hand in cold water and allow it to air dry.

From The Front Of The Patch, Press The Iron Flat In An Up And Down, Vertical Motion (Do Not Move Back/Forth/Around) For 25 To 40 Seconds To Tack The Patch In Place Using The Center Part Of Your Iron.

Turn the iron to the highest temperature setting and then iron the side of the bag/jacket to make sure it's warm, then place the patch where you want to attach it and over a cloth or a towel (so you don't burn the patch) make a few rounds of ironing the patch on. Once it’s secured, cut the design out carefully, leaving the sticky paper backing on. After the time is up try to lift some of the edges while holding down the rest of it.

Once Complete, Do Not Dry The Jeans With A Fabric Sheet, As The Chemicals In The Fabric Sheet Might Cause The Fusible Web To Detach Over Time.

Do not use steam during application! Then you can start the ironing. Leave the little plastic backing on iron patches when sewing the iron on patch onto your fabric.